July 28, 2013
Well the engine went in without any drama. I placed block under the chassis so as I lowered the engine, if it fell if would land on the blocks before crushing all the push-rod tubes - I hoped. As it was everything went well and the engine slid right int he first time. The exhaust is just there to make sure I have the bolts in the
right way on the suspension so nothing hits. I think I am going to use this one as it looks like it fits better than the one I had - although I might swap out collectors - this is a megaphone and the other is a 4 into 2 into 2 style. Had to clean up the roll hoop braces but so far everything fit without shimming. Nothing is tight, just snug, in case I have to take it apart again.....
No comments:
Post a Comment